Improve quality consciousness, let us go further

With the diameter of 250 cylinder in welding bin before the inspection found unsightly cylinder welding seam (Fig. A), the production department timely notice. In the production department to see after the decision to remove the re welding, because in the welding cylinder, the weld should be higher than the parent (cylinder) 3~5mm so as to increase the welding strength and fastness, so that uniform weld appearance.

　　This year we carried out a reform on the tank, compared with the previous product quality has improved, but there are still many deficiencies. For example: the fuel tank in the assembly when there are traces of traces (as shown in figure C), which makes the fuel tank on the road to sweep the next process is to bring a lot of work for the next process, and the product is not beautiful. Now we have improved through the analysis of the scene, to do a set of tooling, we can reduce the use of tools to fight the fuel tank welding (as shown in figure D). This is a significant reduction in the hit point of the fuel tank (as shown in figure E), and we have not only improved the appearance of the oil tank, but also reduced the workload of the next process.

Figure (C): the system fuel tank in the assembly when there are traces of traces, so that the oil tank in the next process when the impact on the appearance of beautiful.

Figure (D): the process is improved, the use of welding in the assembly welding, put an end to the beat phenomenon, improve the appearance of the oil tank neat.

Figure (E): through the work of welding out of the tank is more beautiful than before.

On the problems of piston rod in hoisting and transportation

The piston rod of the lifting piston rod is particularly large long must be matched by 2 people, the tape to check whether the injury of the sling, sling capacity is enough, the sling is clean, then 1 people driving, 1 rotary piston rod, piston rod, prevent hair touch, touch the wound.

The piston rod should be kept in the middle of the piston and the piston rod can be fixed.

The piston rod surface in the assembly is forbidden to beat; in a piston and sleeve should be used when the piston and sleeve on copper.

Only in accordance with the above 3 points to ensure that the surface of the piston rod will not be damaged, in order to ensure the quality of our.

On the issue of valve block

Valve block must be clear and clean, especially in the valve hole should not have iron filings, burrs and other debris. If there are debris, such as iron and steel, when we install the valve will be debugging problems, such as: card valve, the system is not functioning, such as a series of problems.

In the valve block when the valve is not in place which is not completed, should be used to wrap or bulkhead valve hole, bulkhead or bandage, avoid dust and debris into the valve block caused by the valve or valve block damage.

Attention should be paid on driving

The weight of the goods is unknown

Because when you do not know the weight of the goods, you do not know whether the sling and the vehicle can bear, so it is easy to occur should not occur accident.

The vehicle can not be inclined hanging

Because the inclined crane is likely to cause damage to the wire rope and rope damage.

When the vehicle is not in use should pull aside, the hook from the ground to 2 meters.

Because you do not pull aside and 2 meters from the ground, then it is likely that you do not pay attention to will hit the hook.

Through the above points can be seen, the quality consciousness of our employees is gradually improving, I hope you always keep the product quality in the first place, such as the discovery of the quality of what questions to provide more valuable opinions, because the quality is the life of our enterprise, only our strict quality to make our enterprises to go further!

Production department